Achetez 2 articles ou plus et obtenez 10 % DE RÉDUCTION SUPPLÉMENTAIRE sur l'ensemble de votre commande. Ce week-end seulement. Appliqué automatiquement à la caisse.
Impossible de charger la disponibilité du service de retrait
Free Shipping
30-Day Returns
1-Year Warranty
Garantie d'expédition
LIVRAISON GRATUITE sur toutes les commandes au Royaume-Uni . Entièrement assuré.
Délai de traitement 1 à 3 jours ouvrables. (Buy2fix doit traiter votre commande et soumettre tous vos articles à ses tests de contrôle de qualité stricts.)
Temps de transit 5 à 10 jours ouvrables.
Garantie de retour
Pour quelque raison que ce soit, si vous n'êtes pas satisfait de votre commande dans les 7 jours, vous pouvez nous la retourner à l'état neuf pour un remboursement moins les frais d'expédition.
Garantie des articles manquants/incorrects
Si vous recevez un colis contenant des éléments d'emballage manquants/incorrects/secondaires, veuillez nous contacter dans les 7 jours suivant la livraison et fournir la preuve correspondante. Buy2fix effectuera une compensation en fonction de la situation des dommages.
Garantie DOA
Si votre article arrive endommagé, veuillez nous contacter dans les 7 jours et fournir une preuve claire et valide. Buy2fix effectuera une compensation en fonction de la situation des dommages.
Trusted by 80,000+ DIY & repair professionals
1. The peak current can reach 2.3A, enhancing the driving motors capability. 2. There are two modes: normal use/UART mode. Only two pins need to be soldered, and the UART mode can be supported. 3. It can drive the motor to operate in extremely quiet conditions, enabling the motors control sound to be below 15dB, with the noise significantly lower than that of the traditional current control method. 4. Large-area heat dissipation allows the heat of the driving chip to be quickly dissipated through the heat sink, which is beneficial for the normal operation of the printer. 5. High resolution, high-speed anti-shake.
Parameters 1. Microstep: 256 subdivisions 2. Configuration: STEP/DIR OR UART 3. Voltage for driving the load motor: 5.5 - 28V 4. Theoretical current: 2A 5. Default factory current: 0.85A 6. Logic working voltage of the IC: 3 - 5V 7. Recommended current: no more than 1.7A 8. Application: This driver is used on various 3D main control boards. It is only applicable in the 3D printing field. 9. Packing list: TMC2209 driver x 1, heat sink x 1, pins, allen wrench x 1 10. Weight: about 10g
Usage Notes 1. Pay special attention to the drive direction. Do not insert it in the reverse position. 2. When measuring voltage, do not connect the motor; otherwise, it is easy to burn out the driver. 3. When measuring voltage, connect the power supply and do not merely connect the USB power supply. 4. When using the printer control board, please keep the 3 jumper caps under the connector. 5. Before adjusting the knob, it must be done with the power off. After the adjustment is completed, turn on the power for measurement to prevent the driver or motherboard from being burned out. 6. When attaching the heat sink, pay attention to the distance between the heat sink and the pins. Otherwise, it will cause a short circuit between the heat sink and the pins. 7. When the driver is working, ensure proper heat dissipation (heat sink + cooling fan) to prevent abnormal operation due to overheating of the driver.
Verified Compatible
Guaranteed fit for your device. Wrong part? Full refund including shipping.
